Filter Products
Filter Results
$25.94 - $399.00
$56.08 - $56.08
$25.94 - $424.00
Filter by Lunette Eye Size
$25.94 - $399.00
$56.08 - $56.08
$25.94 - $424.00
Videos
for Lunette Ring Locks
Help Articles
for Lunette Ring Locks
Expert Answers
for Lunette Ring Locks
Hey William, InfiniteRule states their hitch locks like the part #34061071-D are made from "high strength" 303 stainless steel and is definitely weldable based on that.
view full answer...Dexter Nev-R-Lube Bearings such as the 50MM #31-71-3 referenced in your question do not have a specific maintenance or replacement schedule. These are pre-lubricated at the factory, which will make it resistant to contamination, and sealed for life…
view full answer...We can get you a good replacement, though there is actually no longer a TDE brand. But that actuator is simply a bolt-on, 7,500 lb actuator that couples to a 2" hitch ball, and per the owner's manual does not have a lockout (so it is…
view full answer...The Oil Cap Kit #RG04-250 is designed for standard 10K - 12K axles and has 3-3/4" diameter threads. This should do the trick for you but I do recommend measuring the diameter of your oil cap first as I wasn't able to find anything…
view full answer...It sounds like you may instead have 7,000lb axles on your two axle dump trailer with a weight like 14,000lbs. I wasn't able to find any information off the numbers you provided. The best thing to do is to take off your hub and find the bearing…
view full answer...If you have a vehicle specific wiring harness for a brake controller then that would indicate that you have a factory tow package and subsequently would already have a 7-way at the back of your vehicle. The universal 7-way connector #ETBC7 is meant…
view full answer...Yes, it is possible. To get started you will need a hub and drum that matches the bearing and seal on your trailer spindle and your wheel bolt pattern. Confirm this by checking the bearing part number, and seal part number. Next, you will need left…
view full answer...You can use the Pollak 7-Way to 12 Volt Power Outlet Adapter #PK11896 but you will need to switch out the connector on your air compressor. You will need to find a male cigarette plug that is rated the same or higher. If you decide to run a line from…
view full answer...You're not going to have any problems mixing Dexter and Lippert components on trailer axles over 10k-lbs in the same manner as below 10k-lbs as long as the measurements on the replacement parts are the same- i.e. bearing sizes are the same, etc..…
view full answer...The Hook and Keeper for Enclosed Trailer Door part #PLR9-A are not spring loaded. That said, we do have spring loaded options like the 45-Degree T-Style Hook and Keeper Door Holder for Enclosed Trailer part #37211765. We don't have any straight…
view full answer...The vehicle awning you'd need is one that bolts to the side of your camper like the Thule Hideaway part #TH490011 as there isn't a version of the Batwing that would attach to your roof rack since it sits up so high and the bars do not extend…
view full answer...On your 2000 Chevrolet Silverado the left and right brake signal wire is separate from your turn signal wires. To connect this style of vehicle wiring to a trailer wiring connector you will need to use a 3-wire to 2-wire connector like the Hopkins…
view full answer...